Table of Contents
Advertisement
Maintenance
(Optional) set lamp alarm
The detector can be instructed to flash the status
indicators when the lamp has been in use for a
certain number of hours.
To set the lamp alarm for the 156 Detector, refer to
the user's guide for the Gilson control software. The
software should include a command that sets the
lamp alarm. Or, the software should allow you to
send a GSIOC command to set the lamp alarm. See
Appendix D
for a listing of GSIOC commands.
To set the lamp alarm via the front panel of a 155
Detector:
1
Press Mode.
2
Press Setup to access setup mode.
3
Press Next until you see:
4
To enable the lamp alarm feature, type a number
from 1 to 9999 and press ENTER.
To disable the lamp alarm feature, type 0 and
press ENTER.
5
Press ESC to exit setup mode.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
4
4-27
Advertisement
Table of Contents
