Table of Contents
Advertisement
Operation
3-6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Software Structure
To operate the detector, you select the operating
mode and then set the run conditions for that
mode. You press soft keys to show and select
options when in a mode.
Mode Selection
At the core of the detector software is mode
selection. You can choose among these modes:
• single wavelength mode
• dual wavelength mode
• scan wavelength mode
• status mode
• setup mode
• file mode
The flow charts on the following pages show the
displays associated with each mode. To select a
mode, press the Mode soft key and then press the
soft key for the desired mode.
Parameter List
After you select a mode, you'll see the first display
for that mode. The display shows current
parameters set for the mode. You can then modify
parameters.
Depending on the mode you selected, you'll see
some or all of the following soft keys.
Next and Previous
If the mode includes additional parameters, you
can access the next parameter display by stepping
forward (Next) or backward (Previous) through the
list. Any time you want to stop modifying
parameters, press ESC.
If you make a mistake while entering a parameter,
press the CLEAR key. The detector removes the
incorrect value so you can enter the correct one. If
the new value is correct, press ENTER to save the
parameter and move the focus to the next parameter.
3
Advertisement
Table of Contents
