Rear Panel Connections - Gilson VERITY 1741 User Manual

Rear Panel Connections

Refer to the diagram below when making the connections described in this section.
Figure 12
VERITY® 1741 UV-VIS Detector - Rear View
NO. DESCRIPTION
1 Combined power socket with main switch and main fuse
2 Connector Ethernet/LAN
3 Connector IO INTERFACE
4 Analog outputs A, B, C, D
Ethernet
To make the Ethernet connection to the instrument, a router and
Ethernet cables are needed.
CONNeCt pOWer tO the rOuter
connect the power supply to the router and then connect the power
supply to a power source.
CONNeCt the INStrumeNt tO the rOuter
Before connecting, ensure that the instrument is powered OFF.
Locate the Ethernet cable that was included in the accessory kit. Plug one end of the cable into
the LAn port on the detector and the other end to an Ethernet port on the router. Press the
connector in until the safety pin snaps in.
CONNeCt the COmputer tO the rOuter
connect one end of another Ethernet cable to an Ethernet port on the router and the other end
to an Ethernet port on the network adapter in the computer.
16
InSTALLATIon
|
VERITY® 1741 UV-VIS DETEcToR