Table of Contents
Advertisement
2
Installation
Insert the dual-pronged plug into one of the
detector's output channels. (Insert the prong with
the GND-labeled tab into the black jack and the
adjacent prong into the red jack.)
Connect the black wire to the other device's "–" or
"low" input. Connect the red wire to the device's
"+" or "high" input.
If the other device requires a dual-pronged plug,
use a Pomona cable adapter (part number
6374022611) to make the necessary connections.
To reduce recorder noise, you may need to connect a
ground strap between the recorder's GND and "–"
input connectors.
Power connection
Locate the appropriate power cord for your line
voltage. Discard the other power cord.
Use the power cord to connect the detector to an
AC power source.
Gilson strongly recommends that you connect the
power cord to the same outlet that powers the other
components in your system (for example, your
computer, printer, and contact device).
Now all essential electrical connections have been
made.
Next, you'll find descriptions of these optional
connections:
• GSIOC connection
• RS-232 connection
• contact connections
Note: You must connect the GSIOC cable if you use
the detector as a data acquisition device in a Gilson
HPLC system. If you won't need the optional
connections, proceed with
Plumbing Setup
on
page 2-12.
2-5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Advertisement
Table of Contents
