Maintenance
7
Press together the two segments of inlet tubing
as shown in the diagrams below. The segment
leading away from the flow cell should be
almost in front of the segment leading into the
flow cell.
8
Insert the inlet tubing clamp into its socket and
tighten.
9
Route the free-end of tubing through the cutout
located at the lower left of the detector's front
panel.
10 If necessary, carefully dry all surfaces of the
flow cell assembly with a piece of lens paper or
lint-free towel.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
4
4-19