Table of Contents
Advertisement
5 SETTINGS AND PROCEDURES BEFORE SYSTEM OPERATION
5.3 Parameter Setting to Slave Station (QJ71PB93D)
5.3.1 Setting FDL address and automatic refresh parameters
5 - 13
Set the parameters displayed below to the QJ71PB93D.
Item
Station number (FDL Address)
Automatic refresh parameters
(Autom. Refresh)
1
1: Set the automatic refresh parameters only when using the automatic refresh.
(1) Parameter setting method
(a) FDL address
The FDL address can be set by either of the following:
• GX Configurator-DP (Refer to Section 5.3.1)
• Sequence program (Refer to Section 7.2)
(b) Automatic refresh parameters
The automatic refresh parameters can be set only in GX Configurator-DP.
(Refer to Section 5.3.1)
The following explains the procedure for setting the FDL address (station number) and
automatic refresh parameters using GX Configurator-DP.
Refer to GX Configurator-DP Version7 Operating Manual for usage of GX
Configurator-DP.
(1) Setting procedure
1) Select [Project]
Set the station number of the QJ71PB93D.
• Setting range
From 0 to 125
Set the parameters to automatically refresh the I/O data
between the QJ71PB93D and CPU module.
[New] in GX Configurator-DP.
MELSEC-Q
Description
5 - 13
Advertisement
Table of Contents
