Epson N6 Series Manipulator Manual page 30

Setup & Operation 2. Specifications
N6-A850**R
LED Lamp
Ether 1
Ethernet cable connectors
NOTE
When the LED lamp is lighting or the controller power is on, current is being applied to

the manipulator. (The LED lamp may not be seen depending on the Manipulator's
posture. Be very careful.) Performing any work with the power ON is extremely
hazardous and it may result in electric shock and/or improper function of the robot system.
Make sure to turn OFF the controller power before maintenance work.
18
Arm #1
Joint #2
Arm #2
User cable connector
User
Ether 2
Base
Joint #1
Arm #3
Joint #3
Joint #4
Arm #4
Joint #5
Arm #5
Joint #6
Arm #6
Air 1
Air 2
One-touch fittings for ø6 mm
pneumatic tubes
N6 Rev.2