Table of Contents
Advertisement
(8) Install the cable fixing plate A to Arm #1.
NOTE
(9) Pass the cable unit to the Arm #1.
NOTE
(10) Pass the cables (connectors) through the hole
(11) Connect the connectors to the board.
N6 Rev.2
Hexagon socket head cap bolts: 2-M4×8
Tightening torque: 4.0 ± 0.2 N·m
Be careful not to tighten the screws with the
cables get caught on the plate.
Do not pass the cables forcibly while the
connectors get caught. Doing so may result
in disconnection of the cables or breakage of
the connectors.
on the end of the Arm #1
Cables (connectors):
BAT_CN3, BAT_CN6
GS01,
LED_CN1
Cables (connectors):
BAT_CN3, BAT_CN6
LED_CN1
Maintenance 4. Cable
211
Advertisement
Table of Contents
