Start Up Through The Front Panel Control; Restart The System After A Controlled Stop Or Alarm Condition; Figure 20 Front Panel Controls - Edwards iXM Series Instruction Manual

3. Press the START button.
4. Press ENTER.
The system will start, the "Running LEDs" on the pump and the "Pump On LED" on the
PDT will flash while the pump is on and warm up. These LEDs will stop flashing and
remain illuminated continuously when the pump has reached full speed.

6.1.3 Start up through the front panel control

To operate the system through the front panel controls, refer to
controls.
1. Press and hold the local control button. The Green 'local control' LED will
illuminate continuously when control is taken. The message 'Keys in Control' will
be displayed on the PDT if connected.
2. Press and hold the start button until the pump starts. The Running LED will flash
while the pump starts and will remain illuminated continuously when the pump
operates normally.

Figure 20 Front panel controls

1. EMS (controlled stop) button 1. EMS (controlled stop) button
3. Start button 3. Start button
5. Local control button 5. Local control button
7. Power LED (green) 7. Power LED (green)
9. Alarm LED (red) 9. Alarm LED (red)
11. PDT (Pump Display Terminal) connection 11. PDT (Pump Display Terminal) connection

6.1.4 Restart the system after a controlled stop or alarm condition

Note:
If the system has automatically shut down because of high pump power, check that the
pump is free to rotate before you restart the system. Contact your supplier.
1. If the EMS button on the front panel is used to shut down the system, the EMS
button must be reset before restarting the system. Turn the EMS button to reset it
then restart the system as described in
2. If the system shut down automatically because of an alarm condition, the alarm
condition must be corrected before you restart the system. Restart the system as
described in
M56635880_D
M56635880_D - Operation
Start-up on page 59
Page 61
Figure: Front panel
2. Running LED (green) 2. Running LED (green)
4. Stop button 4. Stop button
6. Local control LED (green) 6. Local control LED (green)
8. Warning LED (amber) 8. Warning LED (amber)
10. Green Mode LED (green) 10. Green Mode LED (green)
Start-up on page 59.
10/2020 - ©Edwards Limited