Edwards iXM Series Instruction Manual page 55

alarm conditions still present can be viewed in the Status menu, refer to
page 52. Some alarms, such as 1.01 STOP ACTIVATED, remain present until the pump is
manually started from the PDT or front panel controls.
Once all warning and alarm conditions have been removed, the corresponding LED is
extinguished.
Out of date warnings are automatically acknowledged after 36 hours to prevent a build-
up.
PDT menus
There are three menu buttons: Normal, Status and Setup.
NR in the data part of a parameter indicates 'No Reading'.
NP in the data part of a parameter indicates a parameter that is 'Not Present'.
Normal menu
This menu is displayed when the PDT is first plugged into the pump, or can be accessed
when you press the Normal button. Up to four parameters are displayed, press up/down
keys to scroll.
By default there are four parameters displayed in the Normal menu and these can be
changed through the Edit Display attributes menu, accessed from the Setup menu.
Table 20 Normal menu
Description
Serial number
Control holder
Dry pump current
Booster current
Status menu
1. Press the Status button to enter the menu. Press up/down keys to scroll.
2. Press CANCEL to return to Normal menu.
If a device is not installed the associated parameters will not be displayed.
Table 21 Status menu
Description
Serial number
Control holder
Dry pump current
Booster current
Green Mode state
Gate valve open or closed state
Remote gate valve open or close state
M56635880_D
M56635880_D - Commission
Page 52
Typical display
S/N 1234567
NONE IN CONTROL
DP CURRENT 6 A
MB CURRENT 3.5 A
Typical display
S/N 1234567
NONE IN CONTROL
DP CURRENT
MB CURRENT
GREEN MODE STATE Off
GATE VALVE
PB VALVE
10/2020 - ©Edwards Limited
Status menu on
1.1 A
1.1 A
Open
Open