Microtim Operation; Pdt Operation; Front Panel Control Operation; Status Indicators - Edwards iXH100 Instruction Manual

M561-00-880 Issue C
4.1.1

MicroTIM operation

If the system is to be operated by your own control equipment using the MicroTIM, ensure that no other devices have
control of the pumping system. If they do, you must first release control before you can start the pump by the
MicroTIM.
Use your control equipment to set the pump start/stop signal to the interface connector and check that the

Running LEDs are illuminated.
The MicroTIM takes control. The message 'MTIM IN CONTROL' will be displayed on the PDT if connected. The

green 'Tool Control' LED
4.1.2

PDT operation

If the system is to be operated using the PDT:
Connect the PDT to the required PDT connection, front

Figure 4 item 5).
Control must be taken with the PDT - press 'Control' button. The message 'PDT1 IN CONTROL' will be

displayed if the front connection is used and the message 'PDT2 IN CONTROL' will be displayed if the rear
connection of the iXH/iXL is used.
Press START button (refer to

Press ENTER.

The system will start and the Running LEDs on the pump and the Pump On LED on the PDT will flash whilst

the pump is on and warming up. These LEDs will stop flashing and remain illuminated continuously when the
pump has reached full speed.
4.1.3

Front panel control operation

To operate the system using the front panel controls (refer to
Press and hold the 'Local Control' button

will illuminate continuously when control is taken. The message 'Keys in Control' will be displayed on the PDT
if connected.
Press and hold the Start button

will flash whilst the pump is coming on and will remain illuminated continuously when the pump is running
normally.
4.2

Status indicators

Refer to Figures 2 and 4.
Page 40
(Figure 4, item 9) on the rear panel will illuminate.
Appendix A1 for more information).
(Figure 2, item 5). The Green 'Local Control' LED
(Figure 2, item 3) until the pumps starts. The Running LED
Edwards and the Edwards logo are trademarks of Edwards Limited.
(Figure 2, item 11) or rear (iXH/iXL only,
Figure 2):
© Edwards Limited 2012. All rights reserved.
(Figure 2, item 6)
(Figure 2, item 2)