Applications; Figure 2 Controls/Connectors On The Rear Of The System - Edwards iXM Series Instruction Manual

Figure 2 Controls/connectors on the rear of the system

1. Ethernet Local Area Network (LAN) LED 1. Ethernet Local Area Network (LAN) LED
(green) (green)
4. Power LED (green) 4. Power LED (green)
6. Warning LED (yellow) 6. Warning LED (yellow)
8. USB connection 8. USB connection
10. MicroTIM in control LED (green) 10. MicroTIM in control LED (green)
12. EMS interface 12. EMS interface
14. Nitrogen purge connection 14. Nitrogen purge connection
16. RF earth (ground) stud 16. RF earth (ground) stud
18. Cooling water supply return 18. Cooling water supply return
20. Electrical connector locking mechanism 21. Protective earth (ground) stud 20. Electrical connector locking mechanism 21. Protective earth (ground) stud

2.2 Applications

The iXM pumping system is intended for use on applications as shown in
Applications.
The pump warranty will be invalid if the system is used on any other application. Contact
your supplier if you are in doubt, for advice on the suitability of the system for any
particular application.
M56635880_D
M56635880_D - General description
Page 11
2. Ethernet link LED (yellow) 2. Ethernet link LED (yellow)
3. Ethernet connection 3. Ethernet connection
5. System interface connection 5. System interface connection
7. Running and alarm LEDs (2 colours, 7. Running and alarm LEDs (2 colours,
either green or red) either green or red)
9. Accessory interface connection 9. Accessory interface connection
11. Micro TIM connection (if installed) 11. Micro TIM connection (if installed)
13. N 13. N purge adjuster purge adjuster
2 2
15. Exhaust gas outlet 15. Exhaust gas outlet
17. Cooling water supply connection 17. Cooling water supply connection
19. Electrical supply connection 19. Electrical supply connection
10/2020 - ©Edwards Limited
Figure: