Edwards iXM Series Instruction Manual page 31

2. Use correct lifting equipment attached to all lifting eyebolts to move the system
near to its final operating position.
Note:
The iXM3000 has four eyebolts. All other pump variants only have one eyebolt.
3. Adjust the levelling feet to make sure that the system is level and is not supported
by the castors. The recommended jacking height is 5 mm. Refer to
view of the system
4. Remove the lifting eyebolts and replace them with the lifting eyebolt hole plugs
supplied with the system.
5. Make sure that to the emergency stop button is accessible. Refer to
panel
M56635880_D
M56635880_D - Installation
controls. If not, use a disconnect box, refer to
Page 28
Figure: Front
Figure: Front
Accessories on page 93.
10/2020 - ©Edwards Limited