Front Panel Control Operation; Pdt Operation; Microtim Operation; Status Indicators - Edwards iXL600 Instruction Manual

Dry pump systems
Table of Contents

Advertisement

A540-55-880 Issue D
4.1.1

Front panel control operation

To operate the system using the front panel controls (refer to
Press and hold the 'Local Control' button (item 5). The Green 'Local Control' LED (item 6) will illuminate
continuously when control is taken. The message 'Keys in Control' will be displayed on the PDT if connected.
Press and hold the Start button (item 3) until the pumps starts. The Running LED (item 2) will flash whilst the
pump is coming on and will remain illuminated continuously when the pump is running normally.
4.1.2

PDT operation

If the system is to be operated using the PDT:
Connect the PDT to the required PDT connection, front
Control must be taken with the PDT - press 'Control' button. The message 'PDT2 IN CONTROL' will be
displayed if the front connection is used and the message 'PDT1 IN CONTROL' will be displayed if the rear
connection is used.
Press START button.
Press ENTER.
The system will start and the Running LEDs will be illuminated.
Note:
For a list of PDT accessories refer to
4.1.3

MicroTIM operation

If the system is to be operated by the customer control equipment using a MicroTIM, ensure that no other devices
have control of the pumping system. If other devices have control, first release control before starting the pump
using the MicroTIM.
Use the customer control equipment to set the pump start/stop signal to the interface connector and check
that the Running LEDs are illuminated.
The MicroTIM takes control. The message 'MTIM IN CONTROL' will be displayed on the PDT if connected. The
green 'Tool Control' LED
Note:
For a list of MicroTIM accessories refer to
4.2

Status indicators

If the pump encounters a problem, warning/alarm LEDs (refer to
status. Also refer to
Appendix A2
Page 32
Section
7.3.
(Figure
4, item 9) on the rear panel will illuminate.
Section
for corrective actions should the system develop a problem.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Figure
2):
(Figure
2, item 11) or rear
7.3.
Figures 2
and 4) will illuminate to indicate system
© Edwards Limited 2015. All rights reserved.
(Figure 4
item 5).

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ixl600nIxl1000Ixl1000n

Table of Contents