Start Up Through A Microtim; Start Up Through A Pdt - Edwards iXM Series Instruction Manual

▪ The front control panel
▪ Pump Display Terminal (PDT)
▪ System Controller
▪ Tool through the MicroTIM
▪ One of the serial interfaces.
Only one module can control the system at a time. When the system is controlled by one
module, control requests from the others are denied.
In addition to the control modules listed above, contact the supplier for more
information on ways to control the dry pumping system or our other pumping system.
The PDT indicates which module is in control. LEDs are also given on the rear panel, front
panel or PDT, which illuminate to indicate 'in control'.
The pump, as supplied, can only be controlled using the front panel. The PDT and the
MicroTIM are accessories. Refer to
of an integrated pump and abatement system.
To start the system:
1. Switch on the cooling water and nitrogen supply.
2. Switch on the electrical supply.
3. Make sure that the exhaust extraction system is not restricted and that valves in
the exhaust extraction system are open.
The pump can be started using the MicroTIM, the PDT or the front panel control.

6.1.1 Start up through a MicroTIM

To operate the system through a MicroTIM:
1. If the system is to be operated by customer control equipment through the
MicroTIM, make sure that no other devices have control of the system. If the
system is controlled by any device, release the control before you start the pump
with the MicroTIM.
2. Use the control equipment to set the pump start/stop signal to the interface
connector and check that the Running LEDs are illuminated.
3. The MicroTIM takes control. The message 'MTIM IN CONTROL' will be displayed on
the PDT if connected. The green 'Tool Control' LED
the rear of the
A MicroTim is available as an accessory. Refer to

6.1.2 Start up through a PDT

To operate the system through a PDT:
1. Connect the PDT to the necessary PDT connection, front
controls) or rear
2. Press the Control button to take the control with the PDT. The message 'PDT1 IN
CONTROL' is displayed if the front connection is used or the message 'PDT2 IN
CONTROL' is displayed if the rear connection of the system is used. If something
else is in control, error message 'Control locked' appears. Refer to 'Control Holder'
in the Status menu.
M56635880_D
M56635880_D - Operation
(Figure: Front panel
Accessories
system) on the rear panel will illuminate.
(Figure: Controls/connectors on the rear of the
Page 60
controls)
on page 93. The System Controller is part
(Figure: Controls/connectors on
Accessories on page 93.
(Figure: Front panel
10/2020 - ©Edwards Limited
system).