Edwards iXM Series Instruction Manual page 80

Warning message on PDT
Alarm 176.01 - MB Not Running
Alarm 176.13 - No MB Inv Comms
Alarm 184.10 - DP Low Speed
Alarm 186.01 - DP INV zzzzzzzzzzzzz
Alarm 186.01 - DP Not Running
Alarm 186.13 - No DP Inv Comms
Fault Alarm 1.01 - Stop Activated
Cause The emergency stop has been activated.
There is a fault with the EMS circuit or the EMS link plug has not been installed or
is disconnected.
Remedy If the EMS button has been used on the pump, refer to
controlled stop or alarm condition
been used, examine and reset the EMS circuit and restart the pump. The alarm
message will remain on the display until the dry pumping system is restarted.
Fault Alarm 1.01 - Sys Config Fault
Cause The pump system type has not been set properly.
Remedy Contact us for a service engineer to configure the pump system type correctly or
replace the pump controller electronics.
Fault Alarm 39.12 - Exh Press High
Cause The exhaust pressure has reached maximum allowed limit.
Remedy Refer to
that caused the alarm. Refer to
causes and actions.
Fault Alarm 54.12 - MB Mtr Temp High
Cause The booster temperature has reached the maximum allowed so the booster has
stopped.
Remedy Refer to
caused the alarm. Refer to
causes and actions.
Fault Alarm 55.12 - DP Temp High
Cause Pump temperature high alarm, which stops pump.
Remedy Refer to
M56635880_D
M56635880_D - Fault finding
on page 78
on page 79
on page 79
Unplanned shut down and alarms
Unplanned shut down and alarms
Warning 54.11 - MB Mtr Temp High
Warning 55.11 - DP Temp High
Page 77
Action message on PDT
See manual
on page 78 See manual
Check DP Rotor
ffff xxxx yyyy
on page 79
Diag aaaa bbbb
See manual
on page 79 See manual
on page 61 to reset it. If the EMS button has not
on page 80 to find the exhaust pressure
Warning 39.11 - Exh Press High
on page 80 to find the temperature that
on page 71 for causes and action.
Restart the system after a
on page 70 for
on page 71 for
10/2020 - ©Edwards Limited