Edwards iXM Series Instruction Manual page 61

Display attributes menu
1. This is a sub menu of the SETUP menu. Press up/down keys to scroll. Press ENTER
to open a sub menu.
2. Press CANCEL to return to the SETUP menu.
Table 29 Display attributes menu
Normal display (Selects the parameters displayed in Normal)
Units...
SELECT LINE (Normal display selection menu)
1. Press up/down keys to scroll. Press ENTER to open a sub menu.
2. Press CANCEL to return to the Display attributes menu.
3. Refer to
SELECT PARAMETER menu is opened, press up/down keys to scroll through the
parameters. Press ENTER to select the parameter for display.
4. Press CANCEL to return to the SELECT LINE menu.
Table 30 SELECT LINE (Normal display selection menu)
Top Page 1...
Bottom Page 1...
Top Page 2...
Bottom Page 2...
UNITS (Units to display menu)
1. Press up/down keys to scroll. Press ENTER to open a sub menu.
2. Press CANCEL to return to the Display attributes menu.
3. Refer to
units available in each option. Press ENTER to select the display units.
4. Press CANCEL to return to the UNITS menu.
Note:
The configuration options for the PDT are stored in the PDT itself and are not
associated with the pump that the PDT is connected to. This means a user can
transfer a PDT between pumps and keep the same settings. It also means that
different units can be displayed on two PDTs connected to the same pump.
Table 31 UNITS (Units to display)
Pressure...
Temperature...
Speed...
Active Gauge...
M56635880_D
M56635880_D - Commission
Table: SELECT LINE (Normal display selection
Table: UNITS (Units to
Page 58
display). Press up/down keys to scroll through the
(PSI/kPa/ mbar/Torr)
(Centigrade/Fahrenheit/ Kelvin)
(RPM/Hz)
(mbar/Torr/kPA)
menu). In each option the
10/2020 - ©Edwards Limited