Delta Electronics AH500 Manual page 508

4. SR206, SR207: Start/End address of a 32-bit counter for a memory card backup
[Description]
To perform restoration by a memory card, the parameters are used to set the start/end
address of a 32-bit counter
5. SR208, SR209: Start/End address of an S device for a memory card backup
[Description]
To perform restoration by a memory card, the parameters are used to set the start/end
address of an S device.
6. SR210, SR211: Start/End address of a D device for a memory card backup
[Description]
To perform restoration by a memory card, the parameters are used to set the start/end
address of a D device. If the restoration addresses includes SR devices, the SR devices will
not be restored, but the rest of the devices within the restoring range will still be restored.
7. SR212, SR213: Start/End address of a W device for a memory card backup
[Description]
To perform restoration by a memory card, the parameters are used to set the start/end
address of a W device.
8. SR214:Control register for a memory card backup
[Description]
Definition of registers:
Bit Name
[12-0] File name
Control
13
command
Program
14
backup/restoration
Device
15
backup/restoration
Ch ap te r 13 Expa nsio n Storage De vice
Description
For a backup, it stands for the file name stored in
a memory card.
For restoration, it stands for the file name
retrieved from a memory card
To restore devices or programs, set the value of
bit 13 to 0.
To backup devices or programs, set the value of
bit 13 to 1.
The backup of devices includes every device.
To backup or restore programs, set the value of
bit 14 to 1.
When the operation is completed, the value of bit
14 is automatically reset to 0.
To backup or restore devices, set the value of bit
15 to 1.
When the operation is completed, the value of bit
15 is automatically reset to 0.
Reset
value
0x0000
0
0
0
1 3 - 3