Delta Electronics AH500 Manual page 149

Motion control module

Hide thumbs Also See for AH500:

Table of Contents

A H 5 00 M o ti on C on tr ol M od ul e Ma nua l

Instruction code

 The binary value in S is converted into a binary-coded decimal value,

E xp la nat io n

 If a binary number is converted to a binary-coded decimal number which

 BCD can be used to convert the binary value in a positioning unit to a

 SM1049 is an Ox motion subroutine error flag, and SM953 is an O100

 When X0.0 is ON, the binary value in D10 is converted into a

Pulse instruction 16-bit instruction (5 steps) 32-bit instruction (6 steps)

and the conversion result is transferred to D.

is not in the range of 0 to 9,999, the instruction BCD will not be

executed. If a binary number is converted to a binary-coded decimal

number which is not in the range of 0 to 99,999,999, the instruction

DBCD will not be executed.

binary-coded decimal value, and transfer the conversion result to an

external device, e.g. a seven-segment display.

binary-coded decimal value, and the digit in the ones place of the

conversion result is stored in K1M0 (M0~M3).

If D10=001E (hexadecimal number)=0030 (decimal number),

M0~M3=0000 (binary number).

Converting a binary

number into a

binary-coded decimal

Chapters

Table of Contents