Delta Electronics AH500 Manual page 500

will be ON.
 Connecting the Ethernet port on an AH500 series motion control module to PMSoft
If an AH500 series motion control module equipped with an Ethernet port is connected to
PMSoft, users can upload/download and monitor a program through Ethernet.
 Wiring hardware
Users can connect the Ethernet port on an AH500 series motion control module to an
Ethernet port on a personal computer by means of a general networking cable. After an
AH500 series motion control module is connected to a personal computer, the Ethernet
connection LED indicator on the AH500 series motion control module will be ON. If the
Ethernet connection LED indicator is not ON, users have to check whether the setting of
the module or the personal computer is incorrect.

Setting COMMGR

Users can type a driver name in the Driver Name box.

Select Ethernet in the Type drop-down list box in the Connection Setup section.

Select a network interface card in the Description drop-down list box. The IP address
assigned to the network interface card selected is displayed in the lower left corner of
the Ethernet Card section.

Owing to the characteristics of Ethernet, a computer can communicate with all devices
on a network. Users can create the IP addresses of the devices connected to this
driver in the IP Address Setting section.
 After users click Add to add a new IP address to the list of IP addresses in the IP
Address Setting section, they can type related information in the IP Address cell,
the Port Number cell, and the Comment cell.

Users can type the IP address of a device connected in this cell.

Users can type the communication port number specified.

Users can type a comment in this cell.
Ch ap te r 12 Se tting an Ethe rne t Ne tw ork

 
1 2 - 3