Delta Electronics AH500 Manual page 238

Motion control module

Hide thumbs Also See for AH500:

Table of Contents

Instruction code

E xp la nat io n

Pulse instruction 16-bit instruction (1 step) 32-bit instruction

The instruction BRET does not have to be driven by a contact.

After the instruction BRET is executed, the instructions which should be

driven by a conditional contact will seem to be connected to a busbar,

and will be executed.

In the general program shown below, the instructions are executed only

when X0.0 is ON.

After the instruction BRET is added, the instructions which should be

driven by a contact will seem to be connected to a busbar, and will be

Ch ap te r 5 Ap plie d Instruc tions

Returning to a busbar

Chapters

Table of Contents