Setting The Meter Mode; Using Peak Hold - Yamaha S Rev1 Owner's Manual

Setting the Meter Mode

In 4-channel or 2-channel x2 mode, the 14-segment meters that appear on most
RC-SREV1 display pages can be set to display either input or output signal levels by
using the METER MODE option.
In 2-channel mode, meters for both the inputs and outputs (left and right) are always
displayed, so the METER MODE option is not available when this mode is selected.
Use the [UTILITY] button to locate the Meter I/O page.
1
Use the cursor buttons to select the METER MODE button.
2
Use the [ENTER] button to toggle between INPUT and OUTPUT mode.
3
The 14-segment meters are set accordingly.

Using Peak Hold

By keeping the highest lit segment of each meter illuminated, the Peak Hold function
offers a convenient way to check for signal peaks. In addition to the meters on the
RC-SREV1 display pages, the Peak Hold function also works with the dedicated CLIP
indicators on the SREV1 and RC-SREV1.
Use the [UTILITY] button to locate the Meter I/O page.
1
Use the cursor buttons to select the PEAK HOLD button.
2
Use the [ENTER] button to toggle between OFF and ON.
3
The Peak Hold function is set accordingly.
To reset the Peak Hold function, turn it off and then back on again.

Setting the Meter Mode

SREV1—Owner's Manual
39