Getting Access To The Component; Safety Notes; Extending The Server Enclosure Out Of The Rack - Fujitsu PRIMERGY CX400 M6 Upgrade And Maintenance Manual

4.7

Getting access to the component

4.7.1

Safety notes

CAUTION
▶
Only for non-hot plug components:
● Before removing or attaching covers, turn off the server, all
peripheral devices, and any other connected devices.
● Because there is a risk of electric shock or damage, please
disconnect all power cords from the outlet.
▶
The top cover must be replaced as soon as possible for purposes
of cooling, to comply with EMC regulations (regulations regarding
electromagnetic compatibility) and to prevent fires.
▶
For more information, see
4.7.2

Extending the server enclosure out of the rack

CAUTION
▶
Use the anti-tilt plate to prevent the rack from tipping when
installing the rack. Pulling the server enclosure out of the rack
without having installed the anti-tilt plate may cause the rack to tip
over.
▶
Be careful not to pinch fingers or clothes when sliding out the
server enclosure or pushing it back. Failure to do so may cause
injury.
▶
For more information, see
▶ If applicable, remove all external cables and liquid cooling tubes.
▶ If you remove the CX400 M6 server enclosure out of the rack, remove all
server nodes, PSUs, and HDDs/SSDs from the server enclosure, see
"Removing server nodes from the server enclosure" on page
2.5-inch HDD/SSD modules" on page 115
plug PSU" on page
CX400 M6
"Important information" on page
"Important information" on page
100.
Upgrade and Maintenance Manual
Basic hardware procedures
and "Removing the defective hot-
25.
25.
43, "Removing
49