Getting Access To The Component; Safety Notes; Extending The Server Out Of The Rack - Fujitsu PRIMERGY RX2540 M7 Upgrade And Maintenance Manual

4.5

Getting access to the component

4.5.1

Safety notes

CAUTION
▶
Only for non-hot plug components:
● Before removing or attaching covers, turn off the server, all
peripheral devices, and any other connected devices.
● Because there is a risk of electric shock or damage, please
disconnect all power cords from the outlet.
▶
The top cover must be replaced as soon as possible for purposes
of cooling, to comply with EMC regulations (regulations regarding
electromagnetic compatibility) and to prevent fires.
▶
For more information, see
4.5.2

Extending the server out of the rack

CAUTION
▶
Use the anti-tilt plate to prevent the rack from tipping when
installing the rack. Pulling the server out of the rack without having
installed the anti-tilt plate may cause the rack to tip over.
▶
Be careful not to pinch fingers or clothes when sliding out the
server or pushing it back. Failure to do so may cause injury.
▶
For more information, see
▶ Remove all remaining external cables from the I/O panel and expansion
cards.
▶ If you are not using a cable management arm (CMA kit), ensure that the rear
cables are long enough not to be strained or damaged when extending the
server out of the rack.
RX2540 M7
"Important information" on page
"Important information" on page
Upgrade and Maintenance Manual
Basic hardware procedures
33.
33.
55