Getting Access To The Component; Safety Notes; Extending The Server Out Of The Rack - Fujitsu PRIMERGY GX2560 M7 Upgrade And Maintenance Manual

Disconnect the power cords from all PSUs in the same way:
▶ Press the cable clamp down until it disengages (1).
▶ Open the cable clamp (2).
▶ Disconnect the power cord from the PSU and remove it from the cable
clamp (3).
4.4

Getting access to the component

4.4.1

Safety notes

CAUTION
▶
Only for non-hot plug components:
● Before removing or attaching covers, turn off the server, all
peripheral devices, and any other connected devices.
● Because there is a risk of electric shock or damage, please
disconnect all power cords from the outlet.
▶
The top cover must be replaced as soon as possible for purposes
of cooling, to comply with EMC regulations (regulations regarding
electromagnetic compatibility) and to prevent fires.
▶
The height of the rack must not exceed 24 U.
▶
For more information, see
4.4.2

Extending the server out of the rack

CAUTION
▶
Use the anti-tilt plate to prevent the rack from tipping when
installing the rack. Removing the server out of the rack without
having installed the anti-tilt plate may cause the rack to tip over.
▶
Be careful not to pinch fingers or clothes when removing or
installing the server. Failure to do so may cause injury.
▶
For more information, see
GX2560 M7
"Important information" on page
"Important information" on page
Upgrade and Maintenance Manual
Basic hardware procedures
25.
25.
39