Preliminary Steps; Removing The Defective Expansion Card - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

Expansion cards and backup units
9.5.5 Replacing expansion cards in riser modules
Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
9.5.5.1

Preliminary steps

Ê If applicable, "Note on network settings recovery" on page
"Disabling or suspending BitLocker functionality" on page 69
Ê
"Disabling SVOM boot watchdog functionality" on page 70
Ê
"Locating the defective server" on page 51
Ê
"Shutting down the server" on page 53
Ê
"Disconnecting power cords" on page 54
Ê
Ê Remove all external cables from the expansion card to be replaced.
"Getting access to the component" on page 55
Ê
Ê If applicable, disconnect internal cables from the expansion card.
Ê Locate the defective expansion card using the onboard Local Diagnostic
LEDs as described in section
page 425.
9.5.5.2

Removing the defective expansion card

Ê If applicable, remove the riser module 1 as described in section
the riser module 1 (HL)" on page
206
"Onboard indicators and controls" on
193.
Upgrade and Maintenance Manual
Hardware: 5 minutes
Software: 5 minutes
184.
"Removing
RX2540 M1