9.4.3
Replacing an expansion card
Upgrade and Repair Unit
(URU)
Tools: tool-less
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
network controller or the system board.
9.4.3.1
Preliminary steps
"Locating the defective server" on page 43
Ê
Ê If applicable, ensure to note down your current network settings in the
operating system.
"Disabling SVOM boot watchdog functionality" on page 64
Ê
"Disabling BitLocker functionality" on page 63
Ê
"Shutting down the server" on page 45
Ê
"Disconnecting the server from the mains" on page 46
Ê
"Getting access to the component" on page 47
Ê
"Locating the defective component" on page 45
Ê
Ê Remove the corresponding riser module as described in section
riser modules" on page
9.4.3.2
Removing the defective expansion card
Ê Remove the expansion card as described in section
expansion card" on page
RX100 S8
58.
173.
Upgrade and Maintenance Manual
Expansion cards and backup units
Hardware: 10 minutes
Software: 5 minutes
"Removing the
"Handling
175