Physical connections to the components
Information and illustrations here show how the DSL subscriber lines, and the analog
voice facilities are connected to the LPMs and how to make connections to an
IP2000, control module, or COP module in the COP slot.
Connections to modules in the COP slot
The COP module supports hosted operation of the Stinger CR ATM DSLAM unit.
Both the IP2000 and control modules support stand-alone operation. However, all
modules that are installed in the COP slot share some common connectors. The
Figure 3-23 and table identify the connectors that are present on these modules.
Figure 3-23. Connectors for modules in the COP slot
PCMCIA
slots
10/100
Ethernet port
Diagnostic port
Gigabit
Ethernet port
Alarm
input port
The Stinger® Compact Remote ATM DSLAM Getting Started Guide
PCMCIA
slots
Modem port
(STGR-CM-B only)
10/100
Ethernet port
10
LINK
100
ACT
Diagnostic port
Alarm
Gig. E
input port
ACT
LINK
IP2000 Module
Enclosure and Component Installation
Physical connections to the components
155Mbps
optic port
Diagnostic port
Alarm
input port
Control module
FAULT
TA
MISC
FAC
COP module
3-31
Need help?
Do you have a question about the Stinger Compact Remote and is the answer not in the manual?