Lucent Technologies Stinger Compact Remote Getting Started Manual page 109

Initial Stand-alone Configuration
Providing a basic system IP configuration
admin> read ip-interface { { shelf-1 8 2 } 0 }
IP-INTERFACE/{ { shelf-1 first-control-module 2 } 0 } read
admin> set ip-address = 1.1.1.2/24
admin> write
IP-INTERFACE/{ { shelf-1 first-control-module 2 } 0 } written
After you assign IP addresses, you can verify that the Stinger unit is a valid IP host on
its configured network by pinging other network hosts, as shown in the following
example:
admin> ping 1.1.1.56
PING 1.1.1.56: 56 Data bytes
64 bytes from 1.1.1.56: icmp_seq=0 ttl=255 time=0 ms
64 bytes from 1.1.1.56: icmp_seq=3 ttl=255 time=0 ms
^C
--- 1.1.1.56: Ping statistics ---
2 packets transmitted, 2 packets received, 0% packet loss
round-trip min/avg/max = 0/0/0 ms
The Stinger® Compact Remote ATM DSLAM Getting Started Guide 4-13