Lucent Technologies Stinger Compact Remote Getting Started Manual page 172

Safety-Related Electrical, Physical, and Environmental Information
Safety Instructions
2 Installation and maintenance procedures must be followed and performed only
by trained personnel.
3 Use caution when installing or modifying telecommunication lines.
4 This product should be serviced by qualified personnel, or taken to a qualified
repair center for service or repair.
5 Never install this product, or telecommunication connections in wet locations.
6 Never install telecommunication wiring during a lightning storm.
7 Never touch un-insulated telecommunication wires or terminals unless they
have been disconnected at the interface.
8 Warning: To avoid shock or injury, never touch un-insulated wiring or terminals
carrying direct current or ringing current, or leave this wiring exposed.
9 Warning: To avoid shock and injury to service personnel, or electrical fire,
protect and tape wires and terminals carrying direct current or tinging current.
10 To avoid overheating the unit, never block the ventilation slots or openings in
this unit.
11
To avoid electrical fires, all fuses used in this product must be replaced with fuses
of the same type and rating.
12 The installation must have an independent frame ground drop.
13 Caution: Install only equipment identified in the applicable Lucent Technologies
!
Manual(s). Use of other equipment may result in improper connections of
circuitry which could cause fire or injury.
14 Warning: Only use this product with telephone wiring protected by an AVAYA
3B or 3C Primary protector. See instruction manual.
15 Warning: Invisible laser radiation may be present when the enclosure is open
and a fiber optic cable is disconnected. Avoid Direct Exposure to Beam.
16 Warning: Un-terminated optical connections may emit laser radiation.
17 Do Not View With Optical Instruments.
D-4 The Stinger® Compact Remote ATM DSLAM Getting Started Guide