Figure 3-9 Side Mounting Bracket Conversion - Lucent Technologies Stinger Compact Remote Getting Started Manual

Atm dslam
Table of Contents

Advertisement

Enclosure and Component Installation
Mounting the enclosure on a pole
10
Remove the four plastic plugs that fill the mounting points on the side mounting
bracket. If needed, a small screwdriver can be used to help remove the plugs.
11
Place the side mounting bracket on the pole mounting brackets, so that the four
studs that supported the mounting plate are inserted into the mounting points in
the side mounting bracket. Reinstall the nuts on these studs to secure the
ventilation cover on the pole mounting brackets.
Note
Pins in the inside half of the vented cover, still installed on the chassis, rest in
these slots to help support and position the enclosure while aligning the
mounting holes on the ventilation covers to secure the enclosure.
Figure 3-9.
Mount
points
12
Carefully lift the enclosure and position the two shoulder pins in the inside
ventilation cover that is attached to the enclosure into the shoulder slots on the
sides of the exterior ventilation cover that is mounted on the pole mounting
brackets.
13
To secure the chassis, align the four mounting points (two on each side) of the
unit and install the mounting bolts in the ventilation covers.
3-12
The side mounting bracket has two shoulder slots on the top of each side.
Side mounting bracket conversion
Shoulder slots
Mount studs
and nuts
Side mounting bracket
(Install)
The Stinger® Compact Remote ATM DSLAM Getting Started Guide
Rear mounting plate
(Remove, if used to align brackets)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Stinger Compact Remote and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents