Route And Connect The Fibers And Ground Cable Inside The Enclosure; Figure 3-10 Enclosure Fiber Tray Details - Lucent Technologies Stinger Compact Remote Getting Started Manual

Warning
screws. If one-way screws are being removed or loosened with an SSTM14 tool,
sharp metal edges are created on the screw head that can result in injury. After
loosening or removal. Follow local guidelines when replacing one-way screws with
tribunal recessed head screws.
Route and connect the fibers and ground cable inside the
enclosure
Use the following procedure to route the fiber cable into the Stinger CR enclosure.
1 Feed the fiber cable through the watertight fitting on the bottom of the
enclosure. (See "Enclosure cable exit points" on page C-21 for the locations of
the watertight fittings on the bottom of the enclosure.)
2 Securely tighten the water tight fitting by hand.
3 Install a cable shield grounding harness to the fiber optic cable inside the
enclosure.
4 Attach the ground cable from the grounding harness to the grounding point on
the right side of the grounding bar located at the lower left side of the enclosure
(see Figure 3-10).
Figure 3-10. Enclosure fiber tray details
Fiber access slot
Use the following procedure to route and connect the fiber optics within the
enclosure.
1 Loosen the retaining screw on the fiber tray and slide the fiber tray forward.
2 Feed the fiber from the fiber cable up through the access slot near the back of the
fiber tray.
Caution
front mounting support for the fiber tray before feeding it up through the fiber
access slot.
The Stinger® Compact Remote ATM DSLAM Getting Started Guide

Route and connect the fibers and ground cable inside the enclosure

Early models of the Stinger Compact Remote were installed with one-way
Fiber tray mounting support
Fiber cable grounding point
To avoid damage to the fiber, be sure to route the fiber behind the left
Enclosure and Component Installation
Splice tray retaining point
SC connectors
Retaining screw
3-15