Hosted System Management
Monitoring the status of remote shelves
Parameter
remote-shelf-id
remote-shelf-oper-state
name
location
internal-fan-unit-failed An alarm was received from the remote shelf fan to
external-fan-unit-failed An alarm was received from the remote shelf fan to
door-open
over-temperature
contact-closure[N]
host-port:physical-
address
validation-status
6-6
Setting
Shelf ID of the remote shelf represented in this profile.
The state of the remote shelf. The remote-shelf-state-
change alarm will be raised when the operational state
of the remote shelf goes from UP to DOWN or DOWN
to UP state. The reason may be any one of the
following values:
remote-shelf-oper-state-
down
remote-shelf-oper-state-
up
remote-shelf-link-failed Link failure was detected
remote-shelf-discovering Remote shelf discovery in
remote-shelf-discovery-
up
remote-shelf-ms-link-
down
Name of the remote shelf as configured in the
remote-shelf-config profile.
Location of the remote shelf as configured in the
remote-shelf-config profile.
indicate a failure of the internal fan unit (yes or no).
indicate a failure of the external fan unit (yes or no).
An alarm was received from the remote shelf fan to
indicate that the door is open (yes or no).
An alarm was received from the remote shelf fan to
indicate an over-temperature condition (yes or no).
An array of 7 indexed parameters that indicate the
contact closure state (yes if contact closure is detected)
on the corresponding remote shelf.
The physical address of the OLIM port to which the
remote shelf is linked.
Validation status of the remote shelf.
The Stinger® Compact Remote ATM DSLAM Getting Started Guide
The remote shelf is down,
a non-operational state.
The remote shelf is
operating normally.
on the optic link
connecting the Compact
Remote to the OLIM.
progress.
Remote shelf discovered.
The logical control channel
is down between this
remote shelf and the host.
Need help?
Do you have a question about the Stinger Compact Remote and is the answer not in the manual?