Table of Contents
Advertisement
6.1. General
Each
HERMetic
instrument
identified with a 6 digits serial number starting
with the letter G, example G10058. This serial
number is printed on the identification plate as
shown on Figure 7-1.
The HERMetic instrument is fitted with an ULTRA
sensing probe.
The unit emits control beep, continuous beep and
intermittent beep.
When the sensing probe is surrounded by air, a
control beep occurs every 2 sec.
When the sensing probe is in contact with any
petroleum product, the beep is continuous.
When the sensing probe is in contact with water
the beep is intermittent.
Control beep
Continuous beep
Intermittent beep
A light signal (LED) can also be activated that
blinks at the same frequency as the buzzer tones.
This can be useful in noisy environments or at
night.
A backlight can be used at night to light up the
display.
The HERMetic instrument is powered by a 9 Volt
battery stored in the electronic terminal named
instrument unit. Current consumption is very low,
ensuring
long
operation
replacement. A continuous tone means that the
battery needs replacement. If the battery power
is too low, it is no more possible to read the
temperature.
50489/GTEX Chem IIC/1805
6. Description
is
individually
•
•
• • • • • • • • • •
• • •
• • •
without
battery
Maintenance is easy because design is modular
and allows quick exchange of parts.
See also Figure 7-2 to get to know the equipment.
14
Identification plate
Figure 7-1
UTImeter Gtex Chem IIC
Advertisement
Table of Contents
