Specifications; Earthing; Main Power Supply; Power Supply - Honeywell MA-1000 Installation Manual

Hide thumbs Also See for MA-1000:
Table of Contents

Advertisement

MA-1000
5

SPECIFICATIONS

Ambient temperature: - 5 ° C ... + 40 °C
Storage temperature: - 10 °C ... + 50 °C
Relative humidity: 10 % ... 95 % (without condensation)

5.1 Earthing

The earthing system must be performed in conformity with CEI and ISPELS rules or rules valid in the country
where the panel is installed.
In any case, must have a resistance lower than 10 Ohm (measured with disconnected devices). This complies
the CEI 68-12 standard for TN installations.
The earth connection to the control unit is compulsory and it must be performed on the CNAL terminal block.
(refer to basic board).

5.2 Main power supply

The control unit is powered by the mains voltage and, in case of mains breakdown it can continue to normally
operate due to the re-chargeable batteries contained in the same control unit.
The required features for the mains supply are:
Voltage: 100 ... 240 V AC
Frequency: 50 / 60 Hz
Current: max. 1.2 A @ 230 V AC
Particular care must be taken when the installation is performed near powerful electromagnetic
sources (ex. repeaters, radio relays, motors, etc.).

5.3 Power supply

The internal power supply has the following output: 28,8
(Power supply for control unit, user output, external load power supply).
User Output: 28,5
V DC ...

5.4 Battery charger section

Output voltage = 26,5
Output current = max. 0,54 A ~ 500 m Vpp
Number of batteries that can be connected = 2 x 12 V / min. 7 Ah, max. 12 Ah
The battery charger section has the following signalling thresholds
Exhausted battery threshold = 21,5 V DC
Re-charge Fault threshold = 3,4 V DC (voltage difference between the two batteries)
Battery release threshold = 19,5 V DC
Threshold of internal battery resistance =

5.4.1 Batteries

Average duration declared by the manufacturer is 3 ... 5 years at an ambient temperature of + 20 °C.
Life decreases in accordance with a higher operating temperature and possible discharging-
recharging cycles.
Recommended Batteries:
Capacity 7 Ah
Battery Yuasa NP7-12 or NP7-12FR (V0) with bolt connector or comparable.
Faston Capacity (20 h): 12 V / 7 Ah
Dimensions (W x D x H): 151 x 65 x 98 mm
Capacity 12 Ah (max. stand-by capacity)
Battery Yuasa NP12-12B or NP12-12BFR (V0) with bolt connector or comparable.
Faston Capacity (20 h): 12 V / 12 Ah
Dimensions (W x D x H): 151 x 65 x 98 mm
14
28,9 V DC, 1 A with 1 A resettable fuse
... 28,5 Vcc (temperature compensation)
Vcc
600 Ohm
29,0 V DC, 2,30 A ripple max. 500 m Vpp
V DC ...
M-167.1-MA1000-EN / 02.2023

Advertisement

Table of Contents
loading

Table of Contents