Set Boot-Image - Avaya S8700 Maintenance Manual

Maintenance Commands

set boot-image

Use this command to direct the system to use 1 of 2 possible firmware image files
on the TN2501AP circuit pack.
Table 7-42. set boot-image command parameters
Action/Object Qualifier
set boot- board
image location
1
2
NOTE:
You must reseat the circuit pack before the firmware file specified in this
command becomes the active boot image.
7-270 Issue 1 May 2002
Qualifier Description
The physical location of the
circuit pack (UUCSS)
Directs the system to use the
Image 1 firmware file
Directs the system to use the
Image 2 firmware file
Example
set boot-image board 1B08
Default Feature
Permissions s Interactions
init
inads
craft
customer
555-233-143