Avaya S8700 Maintenance Manual page 850

Maintenance-Object Repair Procedures
Angel-Speech Processor Handshake Test (#208)
This test checks the integrity of the communication link between the two
processors on the Announcement circuit pack.
!
CAUTION:
Failure of this test indicates that the Speech Processor is insane and results
in the loss of every integrated announcement on the circuit pack.
Table 8-47. Test #208 Angel-Speech Processor (SP) Handshake Test
Error Test
Code Result Description / Recommendation
2000 ABORT Response to the test request was not received within the allowable time period.
If Error Type 1538 is present in the Error Log, follow the maintenance strategy
recommended for this Error Type.
2100 ABORT Could not allocate the necessary system resources to run this test.
ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The circuit pack cannot be used. Announcement speech memory is cleared
when this test fails. When the problem has been resolved, announcements
must be re-recorded or downloaded to the circuit pack. Refer to Essential
Service Information earlier.
1. Reset the circuit pack by the reset board UUCSS command and then run
2. If there are recurring alarms on this circuit pack caused by this test failing,
!
PASS The communications link between the two processors on the announcement
circuit pack is functioning properly. User-reported troubles on this circuit pack
should be investigated using other circuit pack and port tests. Refer to
"ANN-PT" for a description of the port tests.
8-128 Issue 1 May 2002
this test again. If the test continues to fail, replace the circuit pack.
replace the circuit pack, even if step 1 works.
CAUTION:
Replacing the circuit pack causes a loss of integrated announcements.
Refer to ''Essential Service Information'' on page 8-120
MO.
of the AN-LN-PT
Continued on next page
555-233-143