Avaya S8700 Maintenance Manual page 937

ATM-EI (Expansion Interface Circuit Pack)
Table 8-89. ATM Board Error Query Test (#1259) — Continued
Error Test
Code Result Description / Recommendation
0 NO No board was detected by the test.
BOARD
1. Check the Error Log for wrong board (Error Type 125) or no board (Error
2. Check that the board is properly translated and inserted. If so, check for
3. Run the test again. If it fails, the NCE chip on board could be bad.
Table 8-90. XXYY Error Codes for Test #1259
XX Aux Data
1
2
3
4
5
6
7
8
9
10
11
12
13
14
YY Aux Data
15
16
555-233-143
Type 131). Resolve either of these issues, if applicable.
hyperactivity (Error Type 1538). If hyperactive, use the reset board
UUCSS command.
Replace the board and retest.
(ATM Board Error Query Test)
Description
ATM framer chip failed
NCE chip failed
LANHO critical error
TDM Prog. logic device failed
Every on-board DSP failed
Receive network processor failed
Transmit network processor failed
Memory read failed
Dual UART chip failed
LANHO receive parity error
LANHO FIFO overflow error
LAN Bus timeout
LANHO Xmit FIFO overflow
One or more on-board DSPs failed
Description
Backplane clock failed
Loss of signal
Continued on next page
Continued on next page
Issue 1 May 2002 8-215