Avaya S8700 Maintenance Manual page 783

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

ANL-16-L (16-Port Analog Line)

Table 8-25. Test #161 Loop-Around Test — Continued

Description / Recommendation

The test has been disabled by administration. The default for the

field on the station form is y. Determine why this field has been set to "n" on

this station (this may be due to the ringing application Test #48, which can be

customer or terminal disturbing).

1. To enable the test for the particular analog station being tested, enter

change station extension and set the Test? field on the station to y.

Response to the test request was not received within the allowable time

Could not allocate the necessary system resources to run this test. This

could be due to a failure to seize the port.

1. Retry the command at 1-minute intervals up to 5 times.

The reflective loop around test failed. This could cause noisy or unreliable

connections, or users calling this port may hear an echo. The problem can

also be off-board.

1. Since the test may be affected by a line seizure, repeat the test at

1-minute intervals up to 5 times.

2. Run circuit pack tests to check the IPSI Tone Generator circuit or Tone

Generator circuit pack and the IPSI Tone Detector circuit or Tone

Detector circuit pack by using the test board UUCSS short command.

3. Resolve any problems on the Tone Generator circuit or the Tone

Detector circuit.

4. If the Tone Generator and Tone Detector circuits are functioning properly

and the test still fails and a voice terminal is connected and wired

properly, replace the analog line circuit pack.

Continued on next page

Issue 1 May 2002

Troubleshooting