Avaya S8700 Maintenance Manual page 771

ANL-16-L (16-Port Analog Line)
NPE Crosstalk Test (#6)
This test verifies that this port's NPE channel talks on the selected time slot and
never crosses over to time slots reserved for other connections. If the NPE is not
working correctly, one-way and noisy connections may be observed. This test is
usually part of the long test sequence and executes in about 20 to 30 seconds.
Table 8-20. Test #6 NPE Crosstalk Test
Error Test
Code Result Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run test are not available. The port may be busy
with a valid call. This result is also reported for the system's Music-On-Hold
port when it is off-hook, which it usually is.
1. Enter display port UUCSSpp to determine the station's extension. Enter
2. Retry the command at 1-minute intervals up to 5 times.
1001 ABORT System resources required to run test are not available. This could be due to a
failure to seize the port.
1. Retry the command at 1-minute intervals up to 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be under
heavy traffic conditions or have time slots out-of-service due to TDM-BUS
errors.
1. If the system has no TDM-BUS errors and is not handling heavy traffic,
1003 ABORT The system could not allocate a tone receiver for the test. The system may be
oversized for the number of Tone Detectors present, or some Tone Detectors
may be out of service.
1. Resolve any TTR-LEV errors.
2. Resolve any TONE-PT errors.
3. If neither condition exists, retry the command at 1-minute intervals up to 5
1004 ABORT The port was seized by a valid call during the test. The test has been aborted.
1. Use the display port UUCSSpp command to determine the station
2. Retry the command at 1-minute intervals up to 5 times.
555-233-143
status station extension to determine the service state of the port. If the
port is active, wait until it is idle.
retry the command at 1-minute intervals up to 5 times.
times.
extension. Use the status station command to determine the service
state of the port. If the port is active, wait until the it is idle before testing.
Continued on next page
Issue 1 May 2002 8-49