Avaya S8700 Maintenance Manual page 790

Maintenance-Object Repair Procedures
Table 8-27. Test #6 NPE Crosstalk Test — Continued
Error Test
Code Result Description / Recommendation
0 NO The test could not relate the internal ID to the port (no board). This could be
BOARD due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Verify that the board's translations are correct. Use the list config
2. If the board was found to be correctly inserted in step 1, issue the busyout
3. Issue the reset board command.
4. Issue the release busy board command.
5. Issue the test board long command.
Conference Circuit Test (#7)
This test verifies that the NPE channel for the port being tested can correctly
perform the conferencing function.
Table 8-28. Test #7 Conference Circuit Test
Error Test
Code Result Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port may be
busy with a valid call. This result is also reported for the system's
Music-On-Hold port when it is off-hook, which it usually is.
1. Enter display port UUCSSpp to determine the station's extension.
2. Enter status station extension to determine the service state of the port.
3. If the port is active, wait until it is idle, and retry the command at 1-minute
8-68 Issue 1 May 2002
command, and resolve any problems.
board command.
This should re-establish the linkage between the internal ID and the port. If
not, verify that a valid board is inserted.
intervals up to 5 times.
Continued on next page
Continued on next page
555-233-143