Avaya S8700 Maintenance Manual page 667

test alarms
Parameters
auto-page
failures
step
short
555-233-143
This option provides the ability to continue testing and displaying test
results, by providing a new screen every time the SAT screen is filled with
test results. The screen does not scroll to accommodate new results;
instead a new screen is provided after the current screen fills up.
If the auto-page option is not specified, the SAT screen will not be
refreshed once it is filled with test results and testing will stop until the user
enters the "PAGE" key to continue or the "CANCEL" key to halt the testing.
This requests that only the failures be displayed on the screen. All passes
will not be displayed on the output screen. Hardware failures as well as
aborts, conflicts and PN-down failures will be displayed.
This option will allow the user to step to the next or previous alarm and not
have the current alarm tested. When this option is specified, the user is
presented with the alarm information and prompted for a keypress. The
user may enter CANCEL to abort the command, ENTER to test the
currently displayed alarm, NEXT ALARM (function key) to move to the next
alarm, PREV ALARM (function key) to move to the previous alarm without
testing the currently displayed alarm. If this option is given, then the NEXT
ALARM (function key) or PREV ALARM (function key) may be pressed at
any time during the command (even during test results). If the NEXT
ALARM or PREV ALARM is pressed during a test, the test is aborted,
testing of the current alarm stops, and the next alarm or previous alarm is
displayed. If the first alarms is displayed, and the PREV ALARM is
pressed, then the last alarm is displayed. Also, if the last alarm is currently
displayed, and the NEXT ALARM is requested, then the first alarm will be
shown.
NOTE:
When this option is given the only way to terminate this command is
to press CANCEL.
This will cause the command to execute a series of nondestructive
diagnostic tests.
Issue 1 May 2002 7-411