Avaya S8700 Maintenance Manual page 919

ATM-EI (Expansion Interface Circuit Pack)
Table 8-82. Error Type 1024-1151 Aux Data values (XXYYY) converted to
slot number — Continued
Slot Carrier
A
Failure type
WSP
Slot Set Add Set
# up Party up
18 93 593 893
19 94 594 894
20 95 595 895
21 NA NA NA
22 NA NA NA
j. Error type 1153 — The ATM connection audit found some discrepancy in
the firmware's VC token numbers and live VCs. The problem is rectified in
firmware and no action is needed.
k. Error Type 1281 — The loss of high-level signal indicating operational
problems of equipment located outside of the circuit pack and the fiber
connected to the board. Aux Data values are listed in
Table 8-83. Error type 1281 Aux Data and repair procedures
Aux Alarm
Data Description
15 SYSCLOCK failed
555-233-143
B C
Failure type Failure type
WSP
Set Add Set Set
up Party up up
83 583 883 115 615
84 584 884 116 616
85 585 885 117 617
86 586 886 118 618
87 587 887 119 619
Repair procedure
The board is not locked to the TDM backplane clock signal. This is
probably due to a Tone-Clock problem.
Check for TDM-BUS or TONE-BD errors in the Error Log.
If no other problems are present, reset the circuit pack (reset board
UUCSS)
D
Failure type
WSP
Add Set Set Add
Party up up Party
915 51 551
916 52 552
917 53 553
918 54 554
919 55 555
Continued on next page
Issue 1 May 2002
E
Failure type
WSP WSP
Set Set Add Set
up up Party up
851 19 519 819
852 20 520 820
853 21 521 821
854 22 522 822
855 23 523 823
Continued on next page
Table 8-83.
8-197