Avaya S8700 Maintenance Manual page 930

Maintenance-Object Repair Procedures
Table 8-85. Expansion Interface 2-Way Transmission Test (#241) — Continued
Error Test
Code Result Description / Recommendation
1414 ABORT The active Tone-Clock circuit in one of the EPNs being used for the test has a
MAJOR or MINOR alarm logged against it.
1. Enter display alarms and resolve any TONE-BD and TONE-PT alarms.
1956 ABORT ACL to the board is not up. See ACL status with the list sys-link command
and follow the repair procedures for SYS-LINK.
2000 ABORT Response to the test request was not received within the allowable time period.
2100 ABORT System resources required to run this test are not available.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
FAIL The test tone was not detected correctly in either direction.
1. Test the active Tone-Clocks in the EPNs for which the ATM-EI circuit pack
10MM FAIL The failure codes only apply to a system equipped with an ATM Switch. The
letters "MM" refer to the distant or far-end EPN, and "NN" to the near-end
ATM-EI under test.
The test tone was detected correctly in forward direction (data sent from the
EPN where the circuit pack under test resides and detected correctly in port
network MM), but not the opposite direction.
1. Test the active Tone-Clocks on the "MM" EPN and the EPN where the
2. Ensure that the ATM address of the ATM-EI circuit pack under test
3. Run Test #241 on the active ATM-EI in port network MM. If this test fails
4. If the address was the same, replace the active ATM-EI circuit pack on port
5. If this test fails with Error Code 20NN or 40NN, replace ATM-EI circuit pack
8-208 Issue 1 May 2002
under test provides a link. This determines if the dial tone is supplied.
ATM-EI under test resides (test tone-clock UUCSS). This determines if a
dial tone is supplied.
matches the ATM address on the ATM switch for the port to which this
circuit pack is connected. Refer to ATM Installation, Upgrades, and
Administration for Avaya MultiVantage Solutions book for the procedure to
check the ATM port address on the ATM switch.
with Error Code 10NN or 30NN, go back to step 2.
network MM.
that had the initial problem.
Continued on next page
555-233-143