Avaya S8700 Maintenance Manual page 835

For multi-connect configurations
Hide thumbs Also See for S8700:
Table of Contents

Advertisement

AN-LN-PT (Analog Line Port)
Table 8-43. Test #36 Station Status and Translation Audits and Updates — Continued
Error
Test
Code
Result
Description / Recommendation
1
FAIL
The switchhook audit failed. This result does not indicate a hardware problem.
The other updates were not performed because of this failure. This may occur
if the audit is performed at the same time the terminal equipment goes off-hook.
1. Use the status station extension command to determine when the port is
2. Retry the command at 1-minute intervals up to 5 times.
3. If the test continues to fail, escalate the problem.
5
FAIL
The message waiting lamp update failed. This may be an internal software
error. The translation and ringer updates were not performed because of this
failure.
7
FAIL
The translation update failed. There may be an internal software error. The
ringer update was not performed because of this failure.
8
FAIL
The ringer update failed. There may be an internal software error.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to fail, escalate the problem.
PASS
The software and the port processor have the same status. Investigate
user-reported troubles on this port by running other port tests, by examining
station wiring, or by inspecting the station.
0
NO
The test could not relate the internal ID to the port (no board). This result could
BOARD
be due to incorrect translations, no board is inserted, an incorrect board is
inserted, or an insane board is inserted.
1. Check to make sure that the board translations are correct. Use the list
2. If the board is correctly inserted, issue the busy board UUCSS command.
3. Issue the reset board UUCSS command.
4. Issue the release board UUCSS command.
5. Issue the test board UUCSS long command.
555-233-143
available.
configuration command, and resolve any problems.
This should re-establish the link between the internal ID and the port. If
not, verify that a valid board is inserted.
Continued on next page
Issue 1 May 2002
8-113

Advertisement

Table of Contents
loading

Table of Contents