Avaya S8700 Maintenance Manual page 683

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

test ds1-loop

If the specified board is not inserted in the system, the following message will be

Board not inserted

If the command entered is in conflict with another currently executing command,

then a message will be displayed showing the login id of the conflicting user and

the conflicting command. The message is as follows:

'login id':'command' has a command conflict

If during the execution of a command a resource problem occurs that requires the

user to restart the command, then the following message will be displayed:

Command resources busy; Press CANCEL to clear, and then

If every available maintenance resource is currently in use, then the following

message will be displayed:

All maintenance resources busy; try again later

If the test ds1-loop command is executed and the G3 Version field on the

System Parameters Customer Options form is not V3 or later, then the following

message will be displayed:

G3 Version must be V3 or later

If the test ds1-loop command is executed on a circuit pack other than TN464F or

TN767E or later DS1 board, then the following message will be displayed:

Command valid for TN464F or TN767E or

later release DS1 circuit packs

If the [inject-single-bit-error] parameter is selected, but no CPE loopback jack,

far-end CSU, or one-way span test is active on the DS1 circuit pack, then the

following message will be displayed:

Parameter valid only if a loopback/span test is active on

Issue 1 May 2002

Troubleshooting