Change Synchronization - Avaya S8700 Maintenance Manual

Maintenance Commands

change synchronization

This command is destructive .
This command changes the synchronization source to the system.
Table 7-10. change synchronization command parameters
Action/ Object Qualifier
change
synchronization
cabinet* number
Cabinet number only applies to S8700 IP Connect configurations
Output
The following example shows the output for the change synchronization
command for an S8700 IP Connect configuration.
change synchronization 1
SYNCHRONIZATION SOURCE (circuit pack location)
CIRCUIT PACKS AVAILABLE FOR SYNCHRONIZATION
Location Type Name
01B05 DS1 GERT<>Lulu
01A08 DS1 Gertrude <> 5E
01A09 DS1 GERT Loop 414
01B02 DS1 gertrude <> st1
NOTE: DS1 and BRI TRUNK sources result in stratum 4, type II synchronization
7-72 Issue 1 May 2002
Qualifier Description
1-64
SYNCHRONIZATION PLAN
CABINET 1
Stratum: 4
Primary: 01B02 Secondary: 01A08
Slip
n
y
y
y
Permissions Defaults
init none
inads
craft
Location Type Name
Feature
Interactions
none
Page 1 of 2
Slip
555-233-143