Avaya S8700 Maintenance Manual page 720

Maintenance Commands
Table 7-58. traceroute command parameters
Action/
Object Qualifier
traceroute ip-address
node-name
board
clan-port
source
NOTE:
The default DiffServ and 802.1p/Q parameters downloaded to a IP Media
Processor board will be used in the execution of ping and traceroute
commands which are sourced from that IP Media Processor. By
convention, the recipient of a ping will reply with the same QoS value found
in the received packet, hence the measurements reported should reflect the
behavior of the type of packets sent. IP Media Processor-sourced pings
should reflect audio transport performance and C-LAN-sourced pings
should reflect control information transport performance.
7-464 Issue 1 May 2002
Qualifier Description
where IP address is
www.xxx.yyy.zzz
from node-name form
cabinet-carrier-slot
address of the IP circuit
pack
port 1-17
Example:
traceroute ip-address
123.4.56.789
board 1C14
an endpoint's virtual
port ID
Example:
trace-route ip-address
106.245.27.205 source
S00015
Permissions Defaults
init Primary
inads
craft
customer
Feature
Interactions
None
555-233-143