Avaya S8700 Maintenance Manual page 789

For multi-connect configurations

Hide thumbs Also See for S8700:

Table of Contents

ANL-24-L (24-Port Analog Line)

Table 8-27. Test #6 NPE Crosstalk Test — Continued

Description / Recommendation

The test was aborted due to a configuration problem. This test may not be

applicable, or it may be disruptive to terminal equipment other than a voice

terminal (for example, the modem pool member or Music On Hold).

The test has been disabled by administration. The default for the

on the station form is y. Determine why this field has been set to n on this

station (this may be due to the ringing application Test #48, that can be

customer or terminal disturbing).

1. To enable the test for a particular station being tested, enter change

Response to the test request was not received within the allowable time period.

System resources required to run test are not available. This could be due to a

failure to seize the port.

1. Retry the command at 1-minute intervals up to 5 times.

This test can fail due to either on- or off-board problems. Off-board problems

include EXP-PN and EXP-INTF faults, TDM-BUS faults, and faults associated

with the Tone Detectors/Tone Generators. Clear every off-board problem

before replacing the board. A TDM-BUS problem is usually the result of a

faulty board connected to the backplane, or bent pins on the backplane.

1. Resolve any EXP-PN and EXP-INTF errors.

2. Resolve any TDM-BUS errors.

3. Resolve any TONE-BD or TONE-PT errors.

4. Test the board when the faults from steps 1, 2, and 3 are cleared. Replace

The port is correctly using its allocated time slots. User-reported troubles on

this port should be investigated by using other port tests, by examining station

wiring, or by examining the station.

station extension and set the

the board only if the test fails.

field on the station from n to y.

Continued on next page

Issue 1 May 2002

Troubleshooting