Abnormal Noises; Abnormal Noise When Power Is Turned On - Xerox Phaser 6500 Service Manual

Abnormal Noises

Abnormal Noise When Power is Turned On

Phaser 6500/WorkCentre 6505 Service Manual
Initial Actions
• Check for obstructions or debris in the media path.
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Imaging Unit, PL4.1.21
Fuser, PL6.1.1
Transfer Belt, PL6.1.7
Sub Drive Assembly, PL7.1.1
Main Drive Assembly, PL7.1.2
Troubleshooting Procedure Table
Step Actions and Questions
1
Test the Main Drive (page 4-29):
Service Mode > Engine Diag > Motor
Test > Main Motor FULL2.
Is the noise still present?
2
Reseat the Imaging Unit.
Test the Main Drive (page 4-29):
Service Mode > Engine Diag > Motor
Test > Main Motor FULL2.
Is the noise still present?
3 Check for proper Transfer Belt
installation.
Test the Main Drive (page 4-29):
Service Mode > Engine Diag > Motor
Test > Main Motor FULL2.
Is the noise still present?
Xerox Internal Use Only
General Troubleshooting
Wiring and Plug/Jack Map References
Yes
Go to step 2.
Go to step 3.
Go to step 4.
No
Go to step 5.
Complete
Complete
4-73